- Joined
- Nov 4, 2024
- Messages
- 11
I had two vertical cracks in a molar tooth, one of them was diagnosed as a craze line. I went to a dentist and had the silver filling replaced with composite. She said she “cut-out” one crack and left the craze line. After the filling was done, I could feel a crack across the top edge of the tooth at the top of the craze line that was large enough to stick my fingernail into. It was diagonal and not vertical. I went back to her and she said, that’s not a crack, it’s a natural depression in your tooth where the cusps meet. I was in continuing pain for one month. I went to an emergency dental school clinic and they told me there was a crack there through the natural tooth structure and on the filling. They would not bond it due to liability issues and they said they would only replace the entire filling. I went back to the original dentist and insisted she bond that area. She did, but she told me I should put a crown on the tooth although that might not work either and she didn’t think that was the source of my pain. After the bonding, my pain decreased significantly. However, when I run my finger over the area, it is not flush with the edge of the tooth and there is still a very tiny depression there, and it starts to hurt when I press on it. Shouldn’t the bonding be flush with the edge of the tooth? Is it improperly bonded? Can this be causing my continuing pain? I already went to an endodontist who said I don’t need root canal. Should I insist that she bond the tooth again? I don’t want to get a crown if I don’t have to. I am not concerned about the cost, I just don’t want to lose natural tooth structure and there is no guarantee that will end the pain anyway. None of this appears on any x rays or photos.